Documentation: *Configure FileSystem
Programmer’s Reference Manuals
» Part 17 – *Commands
» *Commands – Sorted By Name
» *Configure FileSystem
*Configure FileSystem
Use
This *Command sets the configured filing system to be used at power on or hard reset.
Syntax
*Configure FileSystem fs_name|_fs_number
Parameters
| fs_name | Filing system Name (e.g. ADFS, Net, RAM) |
| fs_number | Filing System number |
Notes
To specify a Filing System by name, FileSwitch must already have that name registered. This is because FileSwitch converts the name to a number for use.
If the configured Filing System is invalid, then an error will be returned on every subsequent command that tries to access the currently selected filing system, until a valid Filing System is selected.
